IONIT sensors can connect to the IONIT Cloud using a variety of network types including DSL, cable, FiOS, and other broadband services. In addition, for locations where wired broadband is not available or convenient, we offer a variety of cellular hubs for GSM and CDMA networks.
When broadband Internet access is located near the asset to be remotely monitored, our Ethernet Bridge offers a simple, reliable and inexpensive solution. This bridge listens for RF signals from IONIT sensors, then transmits their data via direct Ethernet wired connection to the IONIT Cloud via the Internet.
Our ION-9411 ruggedized indoor-outdoor cellular hub is ideal for commercial environments where there is no broadband Internet access available. The cellular hub is a single box design, fully sealed, and powered by low voltage DC power. It ships with its own DC power supply. Simply installation. Simply located the cellular hub where cell signal is strong, plug the power supply into an available outlet anywhere, then run low-voltage cable between the power supply and hub.
When a connection to the Internet is not available on-site, our cellular modem will transmit data over cellular networks. Simply connect the IONIT Hub to the cell modem, and all remote sensor data will be sent to the IONIT Cloud software. Models available for Verizon Wireless, T-Mobile, Sprint and other cellular networks(additional cell service required).
For locations where the sensors are located too far from the Hub, or the location has cronic "low signal", use the RF Repeater to "bounce" the signal over greater distances. The Repeater receives the sensor's messages and re-transmits them, enlarging the coverage area of your remote sensors. Simply plug the Repeater (ION-9440) into power (power supply included) and setup is done.
For locations where the sensors are located too far from the Hub, or the location has cronic "low signal", use the plug-in Repeater to "bounce" the signal over greater distances. Our ION-9100 plug-in oil tank level display can be configured to operate as a Repeater as well. Simply plug the ION-9100 into the wall-mount USB power adapter (included) and follow the install guide to configure the 9100 in repeater mode. The Repeater receives the IONIT sensor's messages and re-transmits them, enlarging the coverage area of your remote sensor network.